Alarms and events, A alarms and events, Alarms and – GE Industrial Solutions Entellisys System User Manual User Manual
Page 187: Aalarms and events
Sequence of events cause code cross reference index
187
A
A
Alarms and events
A.1 Sequence of events cause code cross reference index
The following table lists the sequence of events cause codes. To view a description of these
events and a troubleshooting guide, see
Alarms and events description and system
troubleshooting guide on page 208
Table A-1 Sequence of events cause code cross reference index
Cause
Event Text
Page
H-0001
HMI Startup
H-0002
HMI Shutdown
H-0003
HMI Resumed Communication with [CPUA/B]
H-0004
HMI Lost Communication with [CPUA/B]
H-0005
HMI couldn't Establish Communication with [CPUA/B]
H-0006
Default CPU set to CPUA
H-0007
Default CPU set to CPUB
H-0008
Messnger Commission Command Sent for Breaker [Name]
H-0009
Messnger Decommission Command Sent for Breaker [Name]
H-000A
IP Address for CPUA Set To [n.n.n.n] From [n.n.n.n]
H-000B
IP Address for CPUB Set To [n.n.n.n] From [n.n.n.n]
H-000C
Frequency Set To [50/60]Hz for [CPUA/B]
H-000D
Caution: Settings Failed Writing Frequency to [CPUA/B]
H-000E
Caution: Settings Failed Writing Commission Status To [CPUA/B]
H-0012
Time Synchronization Disabled
H-0013
Time Synchronization Enabled
H-0014
Time Synchronization Frequency Set To [NN] Hours
H-0015
Time Synchronization Successful
H-0016
Caution: Time Synchronization Failed with [CPU A/B]
H-0018
Caution: Firmware Download Failed for [CPU A/B/Messngr].Unable to Enable Flash
Pgm Mode. Replace CPU