Rainbow Electronics AT89C51SND1C - Manual (Page 157)

157
AT8xC51SND1C
4109E–8051–06/03
Table 133. SPSTA Register
SPSTA (S:C4h) – SPI Status Register
Reset Value = 00000 0000b
Table 134. SPDAT Register
SPDAT (S:C5h) – Synchronous Serial Data Register
Reset Value = XXXX XXXXb
7 6 5 4 3 2 1 0
SPIF WCOL - MODF - - - -
Bit
Number
Bit
Mnemonic Description
7 SPIF
SPI Interrupt Flag
Set by hardware when an 8-bit shift is completed.
Cleared by hardware when reading or writing SPDAT after reading SPSTA.
6 WCOL
Write Collision Flag
Set by hardware to indicate that a collision has been detected.
Cleared by hardware to indicate that no collision has been detected.
5 -
Reserved
The value read from this bit is indeterminate. Do not set this bit.
4 MODF
Mode Fault
Set by hardware to indicate that the SS pin is at an appropriate level.
Cleared by hardware to indicate that the SS pin is at an inappropriate level.
3 - 0 -
Reserved
The value read from these bits is indeterminate. Do not set these bits.
7 6 5 4 3 2 1 0
SPD7 SPD6 SPD5 SPD4 SPD3 SPD2 SPD1 SPD0
Bit
Number
Bit
Mnemonic Description
7 - 0 SPD7:0 Synchronous Serial Data.