AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 224)

SIP–DECT OM System Manual Release 3.0 11 Appendix
Aastra depl-1624/1.0 Page: 224 (241)
•
Instruction settings are made like: = .
•
Data sequence sections starts with the key word “data_sequence”. This key word is
always mandatory to proceed the file. All instructions have to be written before this row.
•
Data sequence record fields are separated by colon “;”. Colons have also to be set for
empty fields if at least one follows which is not empty. Otherwise a position mismatch of
fields will occur.
•
If fields have several values assigned (that may be true for a few local RFP configuration
fields like “ntp_address”), they must be separated by comma “,”.
Notes:
•
Because of data sequence fields are separated by colon the content of that section can
possibly be generated by a *.csv export of Excel Sheet and copied into the configuration
file.
•
Instructions are only proceeded on those fields which are left empty within the data
sequence section.
11.7.1 PP Configuration File (OMM Database)
11.7.1.1 Supported Instructions
Instruction Explanation
start_number Numbers can be generated automatically.
This instruction defines the start value.
no_of_number If “start_number” is given, this instruction
defines the maximum of numbers which are
generated.
ac (authentication code) If set to “number”, “ac” will be equal to
number.
If a value is advised, it will be taken as a start
number which will be increased for each new
record.
additional_pin
sip_user
sip_pw
sos_number If these instructions are set, the value will be
taken as default value for the empty
corresponding field within the data sequence
section records.
SOS/Mandown denote the user specific
numbers. The Locatable, Localization, and
Tracking flags are ignored by Web import.
mandown_number
locatable
localization
tracking