AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 175)

SIP–DECT OM System Manual Release 3.0 9 Configuration und Administration Aspects
Aastra depl-1624/1.0 Page: 175 (241)
Note: An initial configuration of the RFPs (L) 35/36/37 IP / RFP (L) 43 WLAN via the OM
Configurator tool requires a login and password. The default login and password is
“omm” and “omm”. No login is required for the initial configuration of the previous
RFP family (RFPs (L) 32/34 / RFP (L) 42 WLAN. If the RFP is configured by the
OMM later on, the OMM also sets the configuration password. You need to enter the
OMM’s full access user and password in the OM Configurator tool then.
With the launch of SIP–DECT 3.0 the appropriate OM Configurator especially for the stream
‘SIP-DECT’ must be used for the local configuration of RFPs.
There are two modes of operation.
•
The OM Configurator is used to set a VLAN ID but other parameters are still requested via
DHCP.
OR
•
All parameters are set via the OM Configurator and DHCP is not used anymore.
The parameters configurable via the OM Configurator comply with the DHCP option,
please see chapter 9.5.4 for details.