AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 146)

SIP–DECT OM System Manual Release 3.0 8 OM Management Portal (OMP)
Aastra depl-1624/1.0 Page: 146 (241)
8.9.3.1 Creating “Alarm triggers”
In configuration mode you can create new alarm triggers.
1 Click Create . In the General tab enter the alarm trigger parameters.
2 Trigger ID : Enter the Trigger ID. The Trigger ID identifies the alarm scenario and also
selects the source which triggers the alarm.
3 Feature access code : Enter the access code which should be assigned to the alarm
trigger.
4 Comment : Enter a comment for the new trigger.
5 Prefix : This field displays the FAC number which introduces the feature access code
(see also chapter 8.9.1).
6 Number : Enter the number to be called in case of this alarm trigger.
7 Press the OK button.
8.9.3.2 Configuring “Alarm triggers”
In configuration mode you can configure an existing alarm trigger.
1 In the alarm trigger table click on the appropriate trigger entry.
2 Click Configure .
The General tab is displayed showing the current trigger configuration.
3 Change the trigger parameters, see chapter 8.9.3.1.
4 Press the OK button.
8.9.3.3 Deleting “Alarm triggers”
In configuration mode you can delete alarm triggers. The predefined alarm triggers (‘SOS
and ’Man down‘) can not be deleted.
1 In the alarm trigger table click on one or more trigger entries.
2 Click Delete .
3 Confirm the displayed prompt with OK .