AASTRA SIP-DECT (Release 3.0)- OM System Manual - Installation, Administration and Maintenance EN - Manual (Page 140)

SIP–DECT OM System Manual Release 3.0 8 OM Management Portal (OMP)
Aastra depl-1624/1.0 Page: 140 (241)
8.8.7 Subscribing PP Datasets
After adding a PP dataset to the OMM, the PP must be subscribed. The OMM must first be
enabled to allow subscriptions to be take place from PP handsets. Subscribing PP datasets
is possible in the
Overview panel and in the Device panel. To start subscription, press one
of the following commands in the Portable parts menu:
•
Subscription : start PP subscription with configured IPEI. For more information on this
see chapter 7.7.3.1.
•
Wildcard subscription : start PP wildcard subscription (without configured IPEI). In the
Wildcard subscription dialog, which is now opened, enter the Timeout for this
subscription method. Press the Start button. For more information on this see chapter
Note:.
8.8.8 Deleting PP Datasets
Deleting PP datasets is only possible in configuration mode. You can delete the fixed
PP dataset (in case of fixed relation) or only the PP user data resp. the PP device data (in
case of dynamic relation).
To delete one or more existing PP datasets proceed as follows:
1 Select the appropriate PP dataset(s) in the PP table by activating the corresponding
checkbox(es).
2 In the task bar on the right of the Portable parts panel click on the Delete command.
– In the Overview submenu the whole PP dataset will be deleted.
– In the Users submenu only the PP user data will be deleted.
– In the Devices submenu only the PP device data will be deleted.
The Delete [xxx] dialog opens showing a confirmation prompt.
3 Confirm the displayed prompt with OK .
8.8.9 Selecting Columns
You can adapt the parameters shown in the PP table to your needs:
1 In the task bar on the right of the Portable parts panel click on the Select columns
command.
The Select columns dialog opens.