4 telnet, 5 configuring telnet, 4 telnet 23.5 configuring telnet – ZyXEL Communications P-2602HWLNI User Manual
Page 347

Chapter 23 Remote Management Configuration
P-2602HWLNI User’s Guide
347
23.4 Telnet
You can configure your ZyXEL Device for remote Telnet access as shown next. The
administrator uses Telnet from a computer on a remote network to access the ZyXEL Device.
Figure 196 Telnet Configuration on a TCP/IP Network
23.5 Configuring Telnet
Click Advanced > Remote MGMT > Telnet tab to display the screen as shown.
Access Status Select a ZyXEL Device interface from Access Status on which incoming HTTPS
access is allowed.
You can allow only secure web configurator access by setting the HTTP Access
Status field to Disable and setting the HTTPS Access Status field to an
interface(s).
Secure Client
IP
A secure client is a “trusted” computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Apply
Click Apply to save your settings back to the ZyXEL Device.
Cancel
Click Cancel to begin configuring this screen afresh.
Table 138 Remote Management: HTTP
LABEL
DESCRIPTION