ZyXEL Communications P-2602HWLNI - Manual (Page 229)

Chapter 13 Phone Usage
P-2602HWLNI User’s Guide
229
• Remote setting (when you are at another place):
When you hear the dial tone, dial “*04” followed by your extension number.
When you do not need the follow me function, dial “#04” followed by your extension
number to cancel this rule.
13.3.5 Call Pickup
When an incoming internal call rings but the user of the phone is unavailable to receive the
call, you can pick the phone up for this person.
Take the following steps to receive incoming internal calls from your phone.
1 If the ringing phone does not belong to the same group of your phone but you know its
extension number, press “*97#” followed by the extension number of the ringing phone
to receive the call.
2 If the ringing phone belongs to the same group of your phone, press “*97#” to receive
the call.
13.4 Checking the Device’s IP Address
Do the following to listen to the ZyXEL Device’s current IP address.
1 Pick up your phone’s receiver.
2 Press “****” on your phone’s keypad and wait for the message that says you are in the
configuration menu.
3 Press “5” followed by the # key.
4 Listen to the IP address and make a note of it.
5 Hang up the receiver.
13.5 Auto Firmware Upgrade
During auto-provisioning, the ZyXEL Device checks to see if there is a newer firmware
version. If newer firmware is available, the ZyXEL Device plays a recording when you pick
up your phone’s handset.
Press “*99#” to upgrade the ZyXEL Device’s firmware.
Press “#99#” to not upgrade the ZyXEL Device’s firmware.