ZyXEL Communications P-2602HWLNI - Manual (Page 111)

Chapter 7 WAN Setup
P-2602HWLNI User’s Guide
111
Figure 53 More Connections Edit
The following table describes the labels in this screen.
Table 26 More Connections Edit
LABEL DESCRIPTION
General
Active Select the check box to activate or clear the check box to deactivate this node.
Name Enter a unique, descriptive name of up to 20 characters for this node. You can
use alphanumeric characters and the hyphen “-”, underscore “_” and @.
General
Mode Select Routing from the drop-down list box if your ISP allows multiple computers
to share an Internet account.
If you select Bridge, the ZyXEL Device will forward any packet that it does not
route to this remote node; otherwise, the packets are discarded.
Encapsulation Select the method of encapsulation used by your ISP from the drop-down list
box. Choices are PPPoA, RFC 1483, ENET ENCAP or PPPoE.
User Name (PPPoA and PPPoE encapsulation only) Enter the user name exactly as your
ISP assigned. If assigned a name in the form user@domain where domain
identifies a service name, then enter both components exactly as given.
Password (PPPoA and PPPoE encapsulation only) Enter the password associated with the
user name above.