Toshiba T2N - Manual (Page 116)

2.INTERNAL OPERATIONS
User’s manual 103
The transition conditions for each mode are shown below.
•
When power turns to ON
Operation mode
switch
RUN/stand-by
switch
(DIP SW.3)
mode transition factor operation
mode after
transition
RUN OFF(RUN) power on RUN
ON(Stand-by) power on HALT
HALT  power on HALT
•
When operation mode switch is changed
mode before transition
operation mode
operation mode
switch
mode transition factor operation
mode after
transition
HALT HALT
mode switch
→
RUN/
P-RUN
RUN

RUN mode switch
→
HALT HALT
•
When command is executed by peripherals (it is available only in RUN position
of operation mode switch.)
mode before transition
operation mode
operation mode
switch
mode transition factor operation
mode after
transition

RUN command HALT HALT
HALT RUN command RUN RUN
RUN command Force RUN RUN-F
RUN command DEBUG D-HALT
RUN/RUN-F RUN command HOLD HOLD
HOLD RUN command HOLD cancel
RUN/RUN-F
(to previous
mode)
D-HALT RUN Debug function D-RUN
D-RUN RUN detection break point or
command Force Stop D-STOP
RUN Debug function D-RUN
D-STOP
RUN
command D-HALT D-HALT
ERROR

command ERROR RESET HALT
In the above table, the symbol ‘

’ means that mode transition is performed
independing on switchs’ setting or previous operation mode.
Refer to 5.6 for details of bedug mode. The FLT LED of the T2N CPU
module is blinking in DEBUG mode.
NOTE