Quantum Data 802BT - Manual (Page 20)

10 Chapter 1 Getting Started
LVDS interface
The LVDS connector is located on the front of the generator and is labeled “Digital.” It
emulates a digital host video source and is used for testing LVDS-compliant video
displays. The LVDS connector pinouts are shown in the following table.
HDMI interface
The HDMI connector is located on the front of the generator and is labeled “HDMI.” It
emulates an HDMI-compliant video display. The HDMI connector pinouts are shown in the
following table.
HDMI Type A Connector Pinouts (HDMI option only)
Special Sync (S/S) interface
Use the S/S connector to output frame sync, line sync, composite sync, or a special probe
pulse. For more information, see Chapter 12, “ Using Special Sync Output .”
S-Video interface
If you have chosen the TV option your generator will have an S-Video connector on the
right side labeled “SVIDEO.” This is a miniDIN connector that emulates an S-Video
compliant source for outputting composite TV signal.
Pin Signal Pin Signal Pin Signal Pin Signal
1 A0M 10 DDC Clock 19 A0P 28 DDC Data
2 A1M 11 DDC +5 Vdc 20 A1P 29 USB Ground
3 A2M 12 USB+ 21 A2P 30 USB-
4 Clock 1M 13 USB +5 Vdc 22 Clock 1P 31 Shield Ground
5 A3M 14 A4M 23 A3P 32 A4P
6 Shield 15 A5M 24 No Connection 33 A5P
7 No Connection 16 A6M 25 No Connection 34 A6P
8 No Connection 17 A7M 26 No Connection 35 A7P
9 No Connection 18 Clock 2M 27 DDC Ground 36 Clock 2P
Pin Signal Pin Signal Pin Signal
1 TMDS Data 2+ 7 TMDS Data0+ 13 CEC
2 TMDS Data2 Shield 8 TMDS Data0 Shield 14 Reserved (N.C.)
3 TMDS Data2- 9 TMDS Data0- 15 SCL
4 TMDS Data1+ 10 TMDS Clock+ 16 SDA
5 TMDS Data1 Shield 11 TMDS Clock Shield 17 DDC/SEC Ground
6 TMDS Data1- 12 TMDS Clock- 18 +5 V Power