Oregon Scientific SE188 - Manual (Page 20)

19
EN
To view lap records:
1. The stopwatch must be stopped (press ST / SP / +).
2. Press
MEM / LAP / -, then press ST / SP / + or MEM /
LAP / - to select lap.
3. Press SET to view lap record.
The lap records will appear in the following order:
•
Lap time / maximum heart rate
• Split time / average heart rate
• Calorie and fat burn total - per lap
• In zone time - per lap: Time spent without exceeding
your upper or lower heart rate limit
• Above zone time - per lap: Time spent exceeding your
upper heart rate limit
• Below zone time - per lap: Time spent exceeding your
lower heart rate limit
BATTERIES
The SE188 uses two CR2032 lithium batteries, one for the
watch and another for the heart rate chest belt. Both are
already installed. See the table below for battery warnings.
LOW BATTERY ICON DESCRIPTION
/
The battery is too low
to run the backlight
The chest belt battery is
nearly too low to send a
signal to the watch
The batteries typically last one year.
To replace the watch battery:
1. Undo the screws and remove the back plate.
2. Using a thin blunt instrument, hook the release catch
and lift the clip.
3. Replace the old battery and then the battery clip.
4. Replace the back plate and screws.
To replace the chest belt battery:
1. Using a coin, twist the battery door counter-clockwise
until it clicks out of place.