Roland RS-70 - Manual (Page 89)

89
Using the sequencer to create patterns (Pattern mode)
Pattern Mode
Copying parameters from a pattern
(PTN PRM COPY)
This operation copies the settings of a specified pattern to the current
pattern. By using this you can edit more efficiently. The following
four parameters can be copied. Effect-related parameters can also be
copied from a patch.
fig.r06-60i
What
Selects the data to be copied.
VALUE
PART: Copy settings made for each part of a pattern (p. 80).
MFX: Copy multi-effect settings.
CHORUS: Copy chorus effect settings.
REVERB: Copy reverb effect settings.
Press [ ] to access the setting screen for each parameter.
Copying settings made for each part of a
pattern
1. Select “PART.”
fig.r06-64_40
2. Press PAGE/CURSOR [ ].
Use VALUE [-]/[+] to select the copy-source pattern.
fig.r06-65_40
3. Press PAGE/CURSOR [ ].
Use VALUE [-]/[+] to specify the copy-source part.
fig.r06-66_40
You can also select the part by pressing [0]–[9] or by holding
down [SHIFT] and pressing [1]–[6].
4. Press PAGE/CURSOR [ ].
Use VALUE [-]/[+] to specify the copy-destination part.
fig.r06-67_40
You can also select the part by pressing [0]–[9] or by holding
down [SHIFT] and pressing [1]–[6].
5. Press [ENTER].
Settings made for each part of the pattern will be copied to the
current pattern.
When the display indicates “COMPLETED,” the copy operation has
been completed.
Copying effect settings
1. Select “MFX,” “CHORUS,” or “REVERB.”
fig.r06-72_40
2. Press PAGE/CURSOR [ ].
Use VALUE [-]/[+] to specify whether you will copy “PATCH”
effect settings or “PTN (pattern)” effect settings.
fig.r06-73_40
3. Press PAGE/CURSOR [ ].
When copying “PATCH” effect settings
Use VALUE [-]/[+] to select the patch whose effect settings you
want to copy.
fig.r06-74_40
When copying “PTN (Pattern)” effect settings
Use VALUE [-]/[+] to select the pattern whose effect settings
you want to copy.
fig.r06-75_40
4. Press [ENTER].
The effect settings will be copied to the currently selected
pattern.
When the display indicates “COMPLETED,” the copy operation has
been completed.
If you copy multi-effect settings, those settings will be pasted
into the effect parameters of the pattern, regardless of the
MFX
Source setting (p. 79). This means that if the MFX Source is set
to “PART” for either or both the copy source and copy
destination, you may not be able to tell that the copy made any
difference. If the MFX Source of the current pattern is set to
“PART,” change it to “PTN/PERF.” Additionally, if MFX Source
of the copy source is set to “PART,” you will need to select
“PATCH” in the above step 2, and select the patch assigned to
that part in step 3 to copy the effect settings of the patch.
RS-70_e3.book 89 ページ ２００３年６月１８日 水曜日 午後１２時５４分