Roland RS-70 - Manual (Page 135)

135
Performing with an external MIDI device
Performing with an
external MIDI device
Set the same Device ID number used for
recording (p. 127)
If not set to the same Device ID number, the pattern settings
recorded at the beginning of the song cannot be received.
Make sure to start playback at the beginning
of the song
When playback of a song is started at any point other than the
beginning, the pattern settings at the time of recording are not used,
and the song is not played back correctly.
Playing together with the playback
of a recorded performance
You can play the RS-70’s keyboard along with a previous
performance by playing while the recorded material is played back.
In this case, select a Part that was not recorded for playing the
keyboard.
Transposing playback of
performances (Master Key Shift)
If you wish to transpose the playback of a song, use the Master Key
Shift setting. This setting will transpose all Parts except for the Drum
Part. You can specify a transposition of up to +/-2 octaves in
semitone steps.
1. Press [SYSTEM] so it is lit.
2. Use PAGE/CURSOR [ ]/[ ] to select “Master Key Sft.”
fig.r10-23_40
3. Use VALUE [-]/[+] to specify the value (-24– +24).
Value: -24– +24
4. Press [WRITE] to save the settings.
For further information, refer to “How to make the system
function settings” (p. 124).
Press [EXIT] to cancel the operation and return to the previous
page.
Using the RS-70 as a General
MIDI/General MIDI 2 system-
compatible sound module
You can play back music data designed for General MIDI and
General MIDI 2 sound generators by connecting an external
sequencer and using the RS-70 as a sound module.
For instructions on connecting the external sequencer, refer to p.
133.
Playing back General MIDI/General
MIDI 2 music data
Be sure to note the following when playing back General MIDI or
General MIDI 2 music data.
Set the System Exclusive Receive Switch to ON
(p. 127).
When set to OFF, GM System On and GM2 System On MIDI
messages cannot be received. With the factory settings, this will be
“ON.”
Make sure to play back from the beginning of
the song
When playback of a song is started at any point other than the
beginning, the sound generator settings won’t be reset to the default
settings for General MIDI and General MIDI 2, so the song won’t be
played back correctly.
RS-70_e3.book 135 ページ ２００３年６月１８日 水曜日 午後１２時５４分