Roland RS-70 - Manual (Page 123)

123
Using the floppy disk drive
Floppy Disk
Renaming a file (RENAME)
This function changes the name of a file.
File name extensions cannot be changed.
Files on the master disks of the Standard MIDI File releases, etc.
from Roland cannot be renamed.
1. Insert a disk into the floppy disk drive.
2. Press [WRITE] while holding down [SHIFT].
3. Use PAGE/CURSOR [ ]/[ ] to select “7:RENAME.”
fig.r11-25_40
4. Press [ENTER].
5. Use VALUE [-]/[+] to select the song whose name you wish
to change.
6. Press [ENTER].
7. Assign a file name.
For further information, refer to “Assigning a name” (p. 54). It
is not possible to use lowercase characters or some symbols
(space, “ * + , . / : ; < = > ? [ ¥ ]) in filenames.
8. Press [ENTER].
If you decide to cancel, press [EXIT].
When the name has been changed, the display will indicate
“COMPLETED.” This ends the procedure.
Checking the remaining space of
the disk (DISK INFO)
This function displays the remaining space available on the disk.
1. Insert a disk into the floppy disk drive.
2. Press [WRITE] while holding down [SHIFT].
3. Use PAGE/CURSOR [ ]/[ ] to select “8:DISK INFO.”
fig.r11-26_40
4. Press [ENTER].
The display will indicate the space available on the disk.
fig.r11-27_40
RS-70_e3.book 123 ページ ２００３年６月１８日 水曜日 午後１２時５４分