Roland RS-70 - Manual (Page 37)

37
Applying various effects to the sound
Quick Start
ASSIGNABLE
Specifies a function controlled by the D Beam controller.
Use VALUE [-]/[+] and select one of the following functions.
In Patch mode, the effect will apply to the patch. In Pattern mode, the effect will
apply to the patch assigned to the current part. Use [DESTINATION TONE] to
specify the tone (p. 30).
“TxCC#” refers to the controller number of control change messages sent from the
MIDI OUT connector when the D Beam controller is operated. When set to
AFTERTOUCH, Channel Aftertouch messages are sent. Set to AFTERTOUCH
mainly when you want to control an external sound generator with Aftertouch
messages.
Receiving these control change messages from the MIDI IN connector produces the
same effect as moving the D Beam controller.
* When set to MFX PARAMETER1 or MFX PARAMETER2, be sure to note the following.
• When the multi-effects Type is set to 01: STEREO EQ (p. 95) or 42: LOFI (p. 109),
Level is changed regardless of whether MFX PARAMETER1 or MFX
PARAMETER2 is selected.
• When the multi-effects Type is set to 23: 2V PCH SHIFT (p. 103), or 24: FB PCH
SHIFT (p. 104), the two parameters are changed simultaneously.
* When making the LFO RATE, LFO DEPTH or LFO DELAY settings, the effect achieved
differs depending on whether [FILTER LFO] is on or off. When [FILTER LFO] is off, the LFO
alters the pitch (vibrato effect). When [FILTER LFO] is on, the LFO changes the Filter Cutoff
frequency (wah effect).
Value Tx CC# Function/Parameter Changed
MODULATION CC01 Vibrato Effect
PORTA TIME CC05 Portamento Time (p. 58)
VOLUME CC07 Level
BALANCE CC08 The volume balance of LOWER and UP-
PER tones (p. 56)
PAN CC10 Pan (p. 57)
EXPRESSION CC11 Level
PORTAMENTO CC65 Portamento Switch (p. 58)
SOSTENUTO CC66 Holds the sound of the key being pressed
SOFT CC67 Softens the Tone
RESONANCE CC71 Tone Filter Resonance (p. 59)
RELEASE TIME CC72 Tone Envelope Release Time (p. 59)
ATTACK TIME CC73 Tone Envelope Attack Time (p. 59)
CUTOFF CC74 Tone Filter Cutoff (p. 58)
DECAY TIME CC75 Tone Envelope Decay Time (p. 59)
LFO RATE CC76 Tone LFO Rate (p. 58)
LFO DEPTH CC77 Tone LFO Depth (p. 58)
LFO DELAY CC78 Tone LFO Delay (p. 58)
CHO SEND LEVEL CC93 Chorus Send Level (p. 57)
REV SEND LEVEL CC91 Reverb Send Level (p. 57)
MFX PARAMETER1 CC12 The parameter specified by Multi-effect
Control 1 (p. 95)
MFX PARAMETER2 CC13 The parameter specified by Multi-effect
Control 2 (p. 95)
AFTERTOUCH ----
BEND UP ---- Pitch bend effect (center → up)
BEND DOWN ---- Pitch bend effect (center → down)
SEQ START/STOP ---- Starts and stops the Quick Sequencer
RS-70_e3.book 37 ページ ２００３年６月１８日 水曜日 午後１２時５４分