Parameter list, Patch parameters – Roland RS-70 User Manual
Page 165
165
Appendix
Parameter list
Patch parameters
Patches
Patch Common parameters (p. 56)
Patch Tone parameters (p. 57)
Parameters
Value
Name
Patch Name
space, A–Z, a–z, 0–9, ! “ # $ % & ‘ ( ) * + , - . / : ; < = > ? @
[ ¥ ] ^ _ ` { | }
Category
* Refer to
“Selecting a patch by category”
(p. 24).
Key Mode
SINGLE, SPLIT, DUAL
Patch Level
0–127
Tone Balance
-64 (LOWER) – +63 (UPPER)
Split Point
A0–C8
Split Arp
Split Arpeggio
UPPER, LOWER, BOTH
Solo Switch
OFF, ON, UPPER, LOWER
ModulationDst
Modulation Destination
UPPER, LOWER, BOTH
PitchBend Dst
Pitch Bend Destination
UPPER, LOWER, BOTH
Modify Dest
Modify Destination
UPPER, LOWER, BOTH
* This is linked with the panel’s [DESTINATION TONE]
setting.
ExpressionDst
Expression Destination
UPPER, LOWER, BOTH
Active Exp Sw
Active Expression Switch
OFF, ON
Parameters
Value
No.
Original Tone Number
0001–1024
Tone Pan
L64–63R
MFX Switch
Multi-Effects Switch
BYPASS, ON
Chorus Send Lvl
Chorus Send Level
0–127
Reverb Send Lvl
Reverb Send Level
0–127
Coarse Tune
-48– +48
Fine Tune
-50– +50
Portamento Sw
Portamento Switch
OFF, ON
Portamento Time
0–127
Velo Sens Depth
Velocity Sensitivity Depth
-64– +63
Velo Sens Ofs
Velocity Sensitivity Offset
-64– +63
Pitch Bend Range
0–24
Filter LFO
Filter LFO Switch
OFF(PCH), ON(FLT)
LFO Rate
-64– +63
LFO Depth
-64– +63
LFO Delay
-64– +63
Cutoff Freq
Cutoff Frequency
-64– +63
Resonance
-64– +63
Attack Time
-64– +63
Decay Time
-64– +63
Release Time
-64– +63
RS-70_e3.book 165 ページ 2003年6月18日 水曜日 午後12時54分