Roland RS-70 User Manual

Page 13

Panel descriptions

fig.04-01.r

[WRITE] / [DISK] button

WRITE:

Saves patch/pattern/song settings or system settings.

DISK:

By holding down [SHIFT] and pressing this button, you
can make settings related to the floppy disk (p. 119).

[-/+OCT] (Octave Shift) / [-/+TRANSPOSE]
(Transpose) buttons

- /+OCT:

These buttons adjust the pitch of the keyboard
in octave steps (maximum +/-3 octaves) (p. 34).

- /+TRANSPOSE:

Pressing either of these buttons while holding
down [SHIFT] allows you to transpose the
keyboard in semitone steps (-5–+6) (p. 35).

[PHRASE/ARPEGGIO] button

Switches phrase/arpeggio function on/off. To make settings for the
phrase/arpeggio, make this button light and then press [PARAM]
(p. 27).

[CHORD MEMORY] button

Switches chord memory function on/off. To make settings for the
chord memory function, get this button to light and then press
[PARAM] (p. 28).

DISPLAY

This displays information regarding the operation you are
performing.

[V-LINK] button

Switches V-LINK on/off (p. 136).

[NUMERIC] / [AUDITION] button

NUMERIC: When this button is lit, the direct access buttons will

function as a numeric keypad. This lets you directly
input or specify a numerical value for the displayed
item (patch number or parameter).

AUDITION: By holding down [SHIFT] and pressing this button, you

can repeatedly listen to an audition phrase for the
currently selected patch (p. 26).

[0]–[9] (DIRECT ACCESS buttons)

In Patch mode, use these buttons to switch between the sound
categories printed on the panel (p. 24). In Pattern mode, use these
buttons to directly select a pattern to play by specifying the lowest
digit of the pattern number (p. 66). However, if the [NUMERIC],
[PART SELECT], or [TRACK MUTE] buttons are lit, the [0]–[9]
buttons will change to the corresponding function.

[VALUE -/+] buttons

Use these buttons to switch the number of an item (patch, pattern,
various parameters, etc.) in the display, or to increase/decrease a
value. While one of these buttons is first held down and the other is
pressed, the value then changes rapidly. Or, if you hold down
[SHIFT] while using these buttons, the value will change in larger
steps.

RS-70_e3.book 13 ページ２００３年６月１８日　水曜日　午後１２時５４分