Erasing a rhythm set you saved (rhy remove), 65 creating a rhythm set (patch mode) – Roland RS-70 User Manual
Page 65
65
Creating a rhythm set (Patch mode)
Patch Mode (Rhythm)
Initializing the settings of a specific
rhythm tone (RHY INITIALIZE)
This operation initializes the rhythm tone parameters (p. 63) to the
state of the preset rhythm tone before its parameters were edited.
If you want to return all parameters of the selected rhythm set to
the preset state, simply re-select the preset rhythm set from
which you started editing.
The Initialize operation applies only to the currently selected
tone; it will not change the content of other sounds stored in user
memory. If you want to restore all settings to the factory-set
condition, execute the Factory Reset operation (p. 20).
1.
Press [PATCH] so it lights and you are in Patch mode.
2.
Select the rhythm set that contains the rhythm tone you
want to initialize.
3.
Press [UTILITY].
4.
Use PAGE/CURSOR [
]/[
] to select “2:RHY INITIALIZE.”
5.
Press [ENTER].
fig.r04-19_40
6.
Use VALUE [-]/[+] to select the rhythm tone that you want to
initialize.
VALUE:
A 0 (key#21)–C 8 (key#108)
You can also press a key to select the rhythm tone to edit.
7.
Press [ENTER] once again to execute.
When initialization is finished, the display will indicate
“COMPLETED.” This ends the procedure.
Erasing a rhythm set you saved
(RHY REMOVE)
This operation erases the specified user rhythm set. When you erase
a rhythm set, it will no longer be possible to select the rhythm set of
that number. If you newly save a rhythm set in that number, you
will again be able to select it.
1.
Press [PATCH] so it lights and you are in Patch mode.
2.
Press [UTILITY].
3.
Use PAGE/CURSOR [
]/[
] to select “3:RHY REMOVE.”
4.
Press [ENTER].
fig.r04-21_40
5.
Use VALUE [-]/[+] to select the user rhythm set that you want
to erase.
6.
Press [ENTER].
When the data has been erased, the display will indicate
“COMPLETED.” This ends the procedure.
Refer to
Creating a Patch (Patch Mode) (
p. 62
)
about
Transmitting
patch/rhythm settings from the MIDI OUT connector (XFER to
MIDI)
, or
Restoring the factory settings (FACTORY RESET)
.
RS-70_e3.book 65 ページ ２００３年６月１８日 水曜日 午後１２時５４分