Roland RS-70 - Manual (Page 125)

125
Settings common to all modes (System Function)
System Function
Functions of the system
parameters
System parameter functions are explained here according to the
group in which they are found.
Settings common to the entire
system (GENERAL)
LCD Contrast
Adjusts the contrast of the display.
VALUE: 1–10
The LCD CONTRAST setting is saved automatically, and is
retained even while the power is off.
Master Tune
Adjusts the overall tuning of the RS-70. The display shows the
frequency of the A4 note (center A).
VALUE: 415.3–466.2 Hz
Master Key Sft (Master Key Shift)
Shifts the overall pitch of the RS-70 in semitone steps.
VALUE: -24–+24
Master Level
Adjusts the volume of the entire RS-70.
VALUE: 0–127
MFX Remain (MFX Remain Switch)
Specifies whether the MFX settings will also change (OFF) when you
switch patterns, or whether the settings of the previous pattern will
continue to be used (ON).
This setting applies to both Pattern mode and Song mode.
VALUE: OFF, ON
Hold Pedal (Hold Pedal Polarity)
Select the polarity of the Hold pedal. On some pedals, the electrical
signal output by the pedal when it is pressed or released is the
opposite of other pedals. If your pedal has an effect opposite of what
you expect, set this parameter to “REVERSE.” If you are using a
Roland pedal (that has no polarity switch), set this parameter to
“STANDARD.”
VALUE: STANDARD, REVERSE
Local Control (Local Controller)
The Local Controller determines whether the internal sound
generator is disconnected (OFF) from the keyboard controller section
(keyboard, pitch bend/modulation lever, knobs, buttons, D Beam
controller, pedal, and so on); or not disconnected (ON). Normally,
this is left “ON”, but if you wish to use the RS-70’s keyboard and
controllers to control only external sound modules, set it to “OFF.”
VALUE: OFF, ON
Clock Source
Select “MIDI” if you want synchronization-related MIDI messages
(MIDI Clock, Start, Continue, Stop, Song Position Pointer, Song
Select) to be received from an external sequencer. Select “INT” if you
want to synchronize to the RS-70’s internal tempo. The multi-effect
changes will also synchronize to this setting.
VALUE: INT, MIDI
Sync Output (Sync Output Switch)
Set this parameter to ON when you want synchronization-related
MIDI messages (MIDI Clock, Start, Continue, Stop, Song Position
Pointer and Song Select) to be transmitted to an external MIDI
device. If not, set it to OFF.
VALUE: OFF, ON
Settings related to the metronome
(METRONOME)
Mode (Metronome Mode)
Specifies when you want the metronome to sound.
VALUE
OFF: Will not sound.
REC ONLY: Metronome will sound only for recording.
REC&PLAY: Metronome will sound for recording and playback.
ALWAYS: Metronome will always sound.
Level (Metronome Level)
You can adjust the volume of the metronome.
VALUE: 0–10
Sound (Metronome Sound)
Selects the metronome sound.
VALUE
TYPE1: A conventional metronome sound will be heard. A
bell will sound on the first beat.
TYPE2: Clicks will sound.
TYPE3: Beeps will sound.
TYPE4: Cowbell will sound for the first beat, and woodblock
on other beats.
RS-70_e3.book 125 ページ ２００３年６月１８日 水曜日 午後１２時５４分