Roland RS-70 - Manual (Page 86)

86
Using the sequencer to create patterns (Pattern mode)
Note
Specifies the range of notes that will be transposed.
Value: C-1–G 9
Bias
Specifies the amount of transposition, in semitone steps. If the
setting’s value is “0,” no transposition will occur.
Value: -99–+99
Modifying the velocity of notes
(PTN CHG VEL)
This operation modifies the velocity (playing strength) of the notes
recorded in the pattern.
fig.r06-60b
If this operation would result in a velocity greater than 127 (or
less than 1), the result will be limited to 127 (or 1).
Part
Specifies the part whose velocity you wish to change.
If you choose “ALL,” all parts will be specified.
Value: ALL, 1–16
You can also select the part by pressing [0]–[9] or by holding
down [SHIFT] and pressing [1]–[6].
Meas (Measure)
Specifies the range of measures in which the velocity is to be changed.
VALUE
Meas: Specifies the measure from where the velocity will
be changed.
for: Specifies the number of measures for which the
velocity is to be changed. If you select “ALL,” all
velocities from the measure you specified for
Meas
to the last measure of the pattern will be modified.
Note
Specifies the range of notes whose velocities will be modified. You
can also press keys on the keyboard to specify the range.
Value: C-1–G 9
MODE
Specifies how the velocity is to be changed.
VALUE
SET TO: Rewrites all velocities in the specified region to a
fixed value.
BIAS: Adds or subtracts a certain velocity value to/from
the velocities in the specified region. For example, if
you set
BIAS to “20,” a velocity value of 70 will be
modified to 90.
MAGNIFY: Set this parameter if increases or decreases in
velocity variations are desired. For less velocity
variation, use settings of “99%” or less. For more
velocity variation, set it to “101%” or greater. With a
setting of “100%,” velocity values do not change.
Select MODE and press [ ] to display setting screens for each
parameter. Use VALUE [-]/[+] to set the value.
• If you choose SET TO
Value: 1–127
• If you choose BIAS
Value: -99–+99
• If you choose MAGNIFY
VALUE
Magnify: 0–200 [%]
Modifying the note length
(PTN CHG GT)
This operation modifies the gate time (duration) of the notes
recorded in the pattern. This can be used to make the overall
performance more staccato or tenuto.
fig.r06-60c
Part
Specifies the part in which you wish to modify the gate time.
If you choose “ALL,” all parts will be specified.
Value: ALL, 1–16
You can also select the part by pressing [0]–[9] or by holding
down [SHIFT] and pressing [1]–[6].
Meas (Measure)
Sets the range of measures in which you wish to adjust the gate time.
VALUE
Meas: Specifies the measure at which the gate time
adjustment is to begin.
for: Specifies the number of measures to be adjusted. If
you select “ALL,” gate times in the region from the
measure you specified for
Meas to the last measure
of the pattern will be modified.
Note
Specifies the range of notes whose gate time will be modified. You
can also press keys on the keyboard to specify the range.
Value: C-1–G 9
MODE
Specifies how the gate time is to be changed.
VALUE
SET TO: Rewrites all gate times in the specified region to a
fixed value.
RS-70_e3.book 86 ページ ２００３年６月１８日 水曜日 午後１２時５４分