Getting ready, Connecting the rs-70 to external equipment – Roland RS-70 User Manual

Page 17

Getting ready

Connecting the RS-70 to external equipment

The RS-70 does not contain an amp or speaker. You’ll need to listen to it through
powered monitors, a mixer and connected monitors, a stereo system, or through
headphones.
Connect as follows when using the RS-70 as a stand-alone device.

fig.q01-01.e

Before starting the connection procedure, make sure that the power to all
devices has been turned off.

Connect the supplied AC adaptor to the RS-70, and then plug its other end
into a power outlet.

Stereo headphones

AC adaptor

to AC power outlet

Audio
cable

Pedal switch (DP-2, DP-8)

or foot switch

(BOSS FS-5U)

Expression pedal (EV-5)

or pedal switch

Audio set etc.

Monitor speakers

(powered)

Mixer etc.

Power amp

Roland

• To prevent malfunction

and/or damage to
speakers or other
devices, always turn
down the volume, and
turn off the power on all
devices before making
any connections.

• To prevent the

inadvertent disruption
of power to your unit
(should the plug be
pulled out
accidentally), and to
avoid applying undue
stress to the AC adaptor
jack, anchor the power
cord using the cord
hook, as shown in the
illustration.

• Use only the specified

expression pedal (EV-5;
sold separately). By
connecting any other
expression pedals, you
risk causing
malfunction and/or
damage to the unit.

• Audio cables, MIDI

cables, and stereo
headphones are not
included. You will need
to purchase these items
from your dealer.

• In order to take full

advantage of the RS-70’s
performance, we
recommend using a
stereo amp/speaker
system, If you are using a
mono system, make you
connections to the
OUTPUT jack L MONO).

• CONTROL PEDAL jack

can also accommodate
pedal switches.

RS-70_e3.book 17 ページ２００３年６月１８日　水曜日　午後１２時５４分