NEC 140He - Manual (Page 74)

4-2
Starting SETUP Utility
To run the SETUP utility, do as follows:
1. Power on the server.
Our logo appears on the screen (the POST screen may appear depending on the setting in SETUP.).
After a while, any of the following messages appears at the bottom of the screen.
Pattern 1:
Press to enter SETUP or to Network
Pattern 2:
Press to enter SETUP, Service Partition, to Network
Or
Pattern 3:
Press to resume, to enter Setup, to Network
Pattern 4:
Press to resume, to enter Setup, Service Partition, Network
* The displayed message varies depending on the device status.
2. Press F2 to start the SETUP utility and display its Main menu.
If you have previously set a password with the SETUP utility, the password entry screen appears. Enter the
password.
Up to three password entries will be accepted. If you fail to enter the password correctly for three consecutive
times, the server halts. (You can no longer proceed.) Power off the server.
NOTE: The server is provided with two levels of password: Supervisor and User. With the
Supervisor password, you can view and change all system parameters. With the User
password, system parameters available for viewing and changing are limited.