NEC 140He - Manual (Page 44)

2-16
System Board Features
The following subsections describe the system board major components.
Processor
The processor board accommodates one to four 64-bit Intel® Xeon™ MP processors with 1 MB cache in an FC-PGA2
package.
DIMM Memory
To install or replace a DIMM, remove the memory board first.
One memory board is factory-installed in the server. Up to four memory boards (32 GB maximum) can be installed in
the server.
Install the DIMM (Dual Inline Memory Module) into the DIMM socket on the memory board of the server. DIMMs are
installed in the ascending order of DIMM socket numbers in the unit of two modules.
The controller automatically detects, sizes, and initializes the memory array, depending on the type, size, and speed of
the installed DIMMs, and reports memory size and allocation to the server via configuration registers.
NOTE: Use DIMMs that have been provided by us. Contact your service representative or
dealer for a current list of approved memory modules.
Onboard Video
The I/O board incorporates an ATI® Radeon® 7000M graphics accelerator with 16 MB of video SDRAM that supports
all standard IBM VGA modes. The embedded SVGA video subsystem supports:
„ Pixel resolutions up to 1024 × 768
„ CRT and LCD monitors up to 100 Hz vertical refresh rate
The I/O board supports disabling of the onboard video through BIOS Setup or when a plug-in video card is installed in
any of the PCI slots.
On Board RAID Controller
The I/O board includes an on-board RAID controller, which is composed of NQ80332 I/O processor and 53C1030 SCSI
host adapter. The on-board RAID controller supports the following features:
„ Dual-channel Ultra320 SCSI interface (CH0 and CH1)
Connect the HDD cage to CH0, and HDD cage or tape device to CH1.
„ RAID levels 0, 1, 5, and spanning of RAID1 and RAID5
„ 256 MB of cache memory
„ Battery-backup cache memory