Setting span, Spanning of raid1 – NEC 140He User Manual

Page 113

Text mode
Original mode

4-41

Setting SPAN

The setting procedure for SPANNING OF RAID1 and SPANNING OF RAID5 are shown below

SPANNING OF RAID1

Open the configuration creation screen.

Select "Configure"

→ "New Configuration" from the TOP menu to display the screen shown below. This is

the Channel-1 menu screen where the cursor is put on ID=0 position:

Select ID-0/1 hard disks.

Pressing Space changes the display for Channel-1, ID=0 to "ONLIN A01-01" where "A01-01" is blinking.
(The cursor automatically moves to Channel-1, ID=1.) In the same way, press Space on Channel-1, ID=1.
(Where "A01-02" is blinking, the cursor moves to Channel-1, ID=2.) After selecting 2 hard disks (Channel-1,
ID=0/Channel-1, ID=1), press Enter to determine the settings. (Display on each hard disk stops blinking.)