NEC 140He - Manual (Page 196)

6-26
Linux
1. Enter the following command to remove the file.
rm /usr/BmcOnlineUpdate/*
2. Enter the following command to remove the directory.
rmdir /usr/BmcOnlineUpdate
Error Messages
Message Action
Update isn't necessary. The firmware is in up-to-date state.
Illegal data. The data is not for the target device.
Update the firmware with the data of the target device.
BMC information can't be acquired. Check if the remote management card is correctly installed.
Update the firmware after making sure that the card is
correctly installed.
Cannot enter the online mode.
Failed to save the current data.
Cannot enter the update mode.
An error was occurred while data is
being updated.
Termination process failed. BMC is possibly in Busy state.
Try again several minutes later.
The IPMI Driver not found. Install the IPMI driver.
BMC is not supported. The BMC does not support the update function. Updating
by this tool is unavailable.
If updating still fails, contact your service representative.