NEC 140He - Manual (Page 104)

4-32
Menu Description
+Adapter Set disk array controller
+Clear Configuration Clear configuration
*1 ‘FlexRAID PowerFail Set whether to restart after rebuilding
*2 ‘Fast Initialization Set high-speed initialization
*3 ‘Disk Spin up Timing Set hard disk spin-up
*4 ‘Cache Flush Timing Set cache flush timing
*5 ‘Rebuild Rate Set rebuild rate
*6 ‘Alarm Control Set alarm sound (ON / OFF)
+Other Adapter Information Board information display (FW version, etc.)
• FW Supports FW type
• FW Ver FW version
• BIOS Ver BIOS version
• DRAM Memory capacity
• Adapter Type Board series NO.
+Factory Default Set default value
*7 ‘Disable (Enable) BIOS Set BIOS Enable / Disable
+Battery Information Battery information
• Backup Module Existence of battery module
• Battery Pack Existence of battery pack
• Temperature Battery temperature
• Voltage Battery voltage
• Fast Charging Set fast charging status
• No of Cycles The number charge cycle
+Reset Battery Charge Counter Clear battery charge counter
+Other Adapter Options Adapter detailed options
*8 ‘Emulation Set control mode
*9 ‘Auto Rebuild Set auto rebuilding Enable / Disable
• Initiator ID Indicate Initiator ID No.
*10 ‘Cluster Mode Set cluster mode
*11 ‘Multiple PCI Delayed Trans Set PCI bus bridge
*12 ‘Force Boot Forced setting of configuration information(HDD)
*13 ‘Coercion Algorithm Setting parameter for maximum hard disk capacity
‘Abort BI & CC Activities Abort Background initialize or Check Consistency
*14 ‘CC Restoration Select CC Restoration mode
*15 ‘Temporary Offline RAID Set Temporary offline Enable / Disable
+Logical Drive Logical drive operation
+Logical Drives Select logical drive
+Initialize Initialize logical drive
+Check Consistency Check logical drive redundancy
+View/Update Parameters Display logical drive information
• RAID Display RAID level
• SIZE
Display logical drive capacity
• Stripe SIZE
Display stripe size
+
√ Write Policy Set write mode
+
√ Read Policy Set read mode
+
√ Cache Policy Set cache mode
+
√ FlexRAID Virtual Sizing Set virtual sizing Enable / Disable *Do not set to Enable
• #Stripes Display stripe size
• State Display logical drive status
+Physical Drive Physical drive menu
+Physical Drive Selection Menu Physical drive operation
+Rebuild Perform rebuilding
+Format Perform low level format *Do not use
+Make Online Set the disk online