NEC 140He - Manual (Page 106)

4-34
IMPORTANT:
„ Notice status display of "Disable (Enable) BIOS".
Selected Enable : Indicate "Disable BIOS"
Selected Disable: Indicate "Enable BIOS"
„ When "Factory Default" is executed, the setting values are changed.
Set each parameter after executing "Factory Default."
„ Some versions of MegaRAID Configuration Utility change the "Factory Default"
setting value.
Check each parameter setting after executing "Factory Default."
„ The server must be restart after executing "Factory Default."
Operating Procedures for Configuration Utility
Creating/adding configuration
Start MegaRAID Configuration Utility
Set new configuration information (pack/logical drive settings)
Check the logical drive settings
Initialize logical drive
Exit MegaRAID Configuration Utility
Procedures
1. Start MegaRAID Configuration Utility to check each setting parameter.
2. Select "Configure"
→ "New Configuration" from the TOP menu (Management Menu).
Select "View/add Configuration" to add configuration.
IMPORTANT:
„ When a new configuration is created by selecting "New Configuration," the existing
configuration information is cleared. To add configuration information to that existing,
select "View/add Configuration."
„ "Easy Configuration" cannot set logical drive capacity or create SPANNING OF RAID1.
Select "New Configuration" or "View/add Configuration" to execute these.
3. When a confirmation message (Proceed?) is displayed, select "Yes."