NEC 140He - Manual (Page 258)

8-54
RESETTING THE SERVER
„ If the server halts before starting the operating system, press and hold Ctrl and Alt and press Delete.
This restarts the server.
„ Pressing the RESET switch on the front panel reboots the server.
RESET switch
IMPORTANT: Resetting the server clears the DIMM memory and the data in process. To
reset the server when it is not frozen, make sure that no processing is in progress.
FORCED SHUTDOWN
Use this function when an operating system command does not shut down the server, the POWER switch does not turn
off the server, or resetting does not work.
Press and hold the POWER switch on the server for at least four seconds. The power is forcibly turned off. To turn on
the power back again, wait approximately 10 seconds after turning off the power (forced shutdown).
Press and hold the
witch at least 4
seconds.
POWER s
IMPORTANT: If the remote power-on function is used, cycle the power once to load the
operating system, and turn off the power again in the normal way.