NEC 140He - Manual (Page 66)

3-6
CONNECTING PERIPHERAL DEVICES
Connect peripheral devices to the server. The server is provided with connectors for a wide variety of peripheral devices
on its rear panel. The figures on the next pages illustrate available peripheral devices for the server in the standard
configuration and locations of the connectors for the devices.
WARNING
Observe the following instructions to use the server safely. Failure to follow these instructions
may result in death or serious personal injury. See pages 1-3 to 1-8 for details.
Do not hold the power plug with a wet hand.
CAUTION
Observe the following instructions to use the server safely. Failure to follow these instructions
may cause a fire, personal injury, or property damage. See pages 1-3 to 1-8 for details.
Plug in to a proper power source.
Do not connect the power cord to an outlet that has an illegal number of connections.
Insert the power plug into the outlet as far as it goes.
Do not use any unauthorized power cord.
Do not connect any interface cable with the power cord of the server plugged to a power
source.
Device w
(e.g., key
To conn
USB2.0
conne ith USB Interface
board)
ect the device having
interface, use the USB
ctor on the rear panel.
FRONT
Device with serial
interface (e.g.,
modem)
NOTE: Make sure of the cable you are going to connect. The ICMB connector and the
front serial port B connector of this server have the same shape as the LAN connector. Be
careful not to connect a cable to a wrong connector.