Psion Teklogix Schnellstart- Anleitung 7525 - Manual (Page 56)

Chapter 3: Getting To Know The WORKABOUT PRO
Switching The Hand-Held On And Off
26 Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual
• Quad Docking Station (Model #WA4004)—can charge the battery of up to
four WORKABOUT PROs inserted in the docking station.
• Single Battery Charger (Model #WA3001)—charges a single battery.
• Quad Battery Charger (Model #WA3004)—charges up to four spare Stan-
dard or High-Capacity WORKABOUT PRO battery packs.
It can take up to 5 hours to charge a battery. The WORKABOUT PRO’s intelligent
charging system protects the battery from over-charging by terminating the charge
process when the battery is at maximum capacity.
Note: Refer to “Monitoring The Battery And Maximizing Run Time” on page 39
for additional information about the battery.
Important: To avoid damaging the battery, chargers will not begin the charge
process until the battery temperature is between 0° C to 45 °C
(32° F to 113° F).
3.4 Switching The Hand-Held On And Off
Switching On The WORKABOUT PRO
• Press and hold down the key for at least one second.
• When the LED flashes green, release the button.
The startup Today screen is displayed.
Note: If the WORKABOUT PRO is in suspend state, pressing
key ‘wakes’ the unit from this state. The screen in which you were working
before the computer entered suspend state is displayed.
Switching Off The WORKABOUT PRO (Suspend)
Important: Keep in mind that turning off the WORKABOUT PRO does not
result in a complete reboot; rather, the unit enters a power-saving,
“suspend” state. When the unit is turned on from suspend state,
operation resumes within a few seconds.
To switch off the WORKABOUT PRO:
• Press the key, and then press the key.