Psion Teklogix Schnellstart- Anleitung 7525 - Manual (Page 312)

Chapter 9: Peripheral Devices & Accessories
Installation–Chargers And Docking Stations
282 Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual
9.3.1 Installation–Chargers And Docking Stations
When installing a charger or docking station at your site, consider the following
guidelines.
• Keep chargers and docking stations away from excessive dirt, dust and
contaminants.
• Chargers will not charge batteries outside an ambient temperature range
of 0° C to 45 °C (32° F to 113° F). It is recommended that the charger or
docking station be operated at room temperature
– between 18° C and 25° C
(64° F to 77° F) for maximum performance.
After unpacking your unit:
• Visually inspect the charger for possible damage.
• Install the IEC power cord and apply power.
9.3.2 Power Consumption Considerations
Check to ensure the mains circuit supplying chargers and/or docking stations is
adequate for the load, especially if several chargers and docking stations are being
powered from the same circuit.
• Quad charger – can consume up to 2A @ 120VAC or 1A @ 240VAC.
• Quad docking station – can consume up to 3A @ 120VAC or 1.5A @
240VAC.
9.3.3 Operator Controls
WORKABOUT PRO docking stations and chargers have no operator controls or
power switches.
9.3.4 Important Charger Safety Instructions
• SAVE THESE INSTRUCTIONS – This manual contains important safety and
operating instructions for battery charger s.
• Before using the battery charger, read all instructions and cautionary
markings on (1) battery charger, (2) battery, and (3) product using battery.
• The mains power cord shall comply with national safety regulations of the country
where the equipment is to be sold.
• Use of an attachment not recommended or sold by the battery charger
manufacturer may result in fire, electric shock, or personal injury.