Psion Teklogix Schnellstart- Anleitung 7525 - Manual (Page 183)

Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual 153
Chapter 6: Settings
Modem Information
6.21.5.5 Modem Information
The fields in this dialog box cannot be edited – they only display information about
the WORKABOUT PRO modem.
If the network operator has not programmed a user’s phone number into his SIM,
the Phone: field remains empty.
If the main menu shows an error status, at least partial modem information may
be available.
Modem Power Modes
The power mode of the modem is controlled through the Power icon rather than
through the Wireless WAN user interface.
To adjust PC Card and CF card modems settings:
• Tap on Start, Settings, and then tap on the System tab followed by the
Power icon.
• Tap on the Card Slots tab.
If the checkbox for a modem is unchecked, power is not applied to the modem and a
driver is not loaded (neither the serial port driver nor the Wireless WAN driver). If
the checkbox is checked, power is applied to the modem and the drivers are loaded
when the hand-held is turned on. Power is removed from the modem when the
WORKABOUT PRO enters suspend mode.
To adjust settings for a modem module that is built into the unit:
• Tap on Start, Settings, and then tap on the System tab followed by the
Power icon.
• Tap on the Built-In Devices tab.
Disabled
Power is not applied to the modem and a driver is not loaded.
Enabled–Off in Suspend
Power is applied to the modem and the drivers are loaded when the unit is turned on.
Power is removed from the modem when the hand-held enters suspend mode.