2 connecting to a lan using an 802.11b radio – Psion Teklogix Schnellstart- Anleitung 7525 User Manual
Page 103
Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual
73
Chapter 5: Connecting To A LAN With 802.11b
Connecting To A LAN Using An 802.11b Radio
•
Fit the mechanical stopper over the card, and use the four screws provided
to secure the stopper in place. Tighten the screws to a torque of 2 kg(f)-cm
(0.145 lb-ft, 0.196 N-m), or until finger tight.
Figure 5.4 Mechanical Stopper Installed
•
Slide the SW1401 switch to the right to turn power back on.
•
Replace the end-cap, and tighten the four Phillips screws to secure
the end-cap.
•
Install the battery, and replace the backplate.
Important:
The WORKABOUT PRO does not support hot swapping cards.
All power sources must be switched off before inserting a card
in the unit.
5.2 Connecting To A LAN Using An 802.11b Radio
Networks that have already been configured are preferred networks and are listed in
Wireless Networks. You can choose to connect to only preferred networks or to
have the WORKABOUT PRO search for and connect to any available network.
1. Tap on Start, Settings. Tap on the Connections tab followed by the
Network Cards icon.
The Configure Wireless Networks screen is displayed with the Wireless tab opened.
This tab lists existing networks to which you can connect, and it allows you to add a
new network or modify the settings for an existing network.
Mechanical Stopper
Installed