Kawasaki D Series Controller MPVDCONTV113E-3 - Manual (Page 191)

TROUBLESHOOTING
D SERIES CONTROLLER
TROUBLESHOOTING AND COMPONENT REPLACEMENT
1-188 August 9, 2005
Ka a a w s k
ERROR CODE P2039 Cannot start cycle from FN instruction.
This error occurs when an FN instruction is the first step at cycle start.
⇒
Do not execute cycle start at a step containing an FN instruction.
_____________________________________________________________________
ERROR CODE P2040 Card is not ready.
The controller tried to read the PC card, but the PC card is not inserted.
⇒
Insert PC card and re-execute.
_____________________________________________________________________
ERROR CODE P2041 Wrong card loaded.
The PC card inserted in the controller cannot be used or is defective.
⇒
Insert a usable PC card .
_____________________________________________________________________
ERROR CODE P2042 Card is write-protected.
An attempt is made to overwrite or delete data on a PC card that is write-protected.
⇒
Remove write-protection and re-execute .
_____________________________________________________________________
ERROR CODE P2043 Card battery is low voltage.
An attempt is made to access a PC card with low battery voltage.
⇒
Replace card battery and re-execute .
_____________________________________________________________________
ERROR CODE P2044 Card is not formatted.
An attempt is made to access a PC card that is not formatted.
⇒
Insert a formatted PC card.
⇒
Use AUX 0204 to format the SRAM PC card.
_____________________________________________________________________