Kawasaki D Series Controller MPVDCONTV113E-3 - Manual (Page 154)

TROUBLESHOOTING
1-151 August 9, 2005
D SERIES CONTROLLER
TROUBLESHOOTING AND COMPONENT REPLACEMENT
Ka a a w s k
ERROR CODE E6526 No response from laser sensor controller.
Main causes include:
1. Disconnected or defective laser sensor harness.
2. Incorrect laser sensor settings or defective laser sensor.
⇒
Check laser sensor, laser sensor harness and connections and repair/replace as
necessary
.
⇒
Refer to the laser sensor operation manual and ensure correct set-up and operation
procedures are used.
_____________________________________________________________________
ERROR CODE E6527 Laser sensor communication error. Code is XX.
Incorrect laser sensor settings or defective laser sensor.
⇒
Refer to the laser sensor operation manual for sub-code XX and ensure correct set-
up and operation procedures are used.
_____________________________________________________________________
ERROR CODE E6528 Start point not found by laser sensor.
Main causes include:
1. The laser sensor unable to find a groove.
2. The laser sensor detected a groove that does not match the specified groove number
data.
3. The laser sensor controller EMERGENCY STOP switch is pressed.
4. Incorrect laser sensor settings or defective laser sensor.
⇒
Re-teach the groove data .
⇒
Ensure the correct groove number is specified.
⇒
Release the laser sensor controller EMERGENCY STOP switch.
⇒
Refer to the laser sensor operation manual and ensure correct set-up and operation
procedures are used.
_____________________________________________________________________