Konica Minolta 7222 - Manual (Page 211)

Copying Image in the Center of Copy Paper (AUTO Layout) (continued)
9-41
• Non-Image Area Erase will be selected automatically.
• When using the Book Copy with this function, an original smaller than the
selected paper size will be printed in the center of the copy paper without
image division performed.
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select the desired magnification and paper size on the Basic Screen.
• APS and AMS are automatically released, and 1.00 (100%) is selected as a
magnification ratio.
• Copy mode is automatically set to 1-1. When selecting 1-2 mode, Platen
store mode will function automatically.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
6.
Position original FACE DOWN on the platen glass.
For details on positioning originals, see p. 3-5 to p. 3-6.
DO NOT close the RADF or platen cover when Non-Image Area Erase is
selected.
Placing original obliquely on the platen glass may cause black copy marks.
7.
Press [START].
When the finisher / inner / paper exit tray capacity is exceeded due to
the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
The AUTO layout function may not operate properly if lighting is directly over
the platen glass. In this case, consult your service representative about an
appropriate place for installation.
9
Applications
Reverse
Image
Non-Image
Area Erase
Book Copy
Image Insert
Transparency
Booklet
Combination
Chapter
Sheet/Cover
Insertion
Application
Selection Screen
Repeat
Upside Down
Frame/Fold
Erasure
AUTO
Layout
Image Shift
Reduce &
Shift
Stamp
Overlay