Sharp JW-20CM - Manual (Page 7)

Table of contents
Chapter 1 Outline ................................................................................................................................... 1·1
Chapter 2 Safety Precautions ............................................................................................................... 2·1
2-1 Installation 2·1
2-2 Wiring 2·1
2-3 Treatment 2·3
2-4 Static electricity 2·3
2-5 Maintenance 2·3
Chapter 3 System Configuration .......................................................................................................... 3·1
Chapter 4 Name and Function of Each Part ........................................................................................ 4·1
4-1 JW-20CM 4·1
4-2 JW-20RS 4·3
Chapter 5 Installation ............................................................................................................................. 5·1
5-1 JW-20CM 5·1
5-2 JW-20RS 5·4
Chapter 6 Processing of Cables ........................................................................................................... 6·1
6-1 Processing cable end 6·2
6-2 Connector crimping procedure 6·5
Chapter 7 Wiring .................................................................................................................................... 7·1
7-1 Cable trunk and branch lines 7·1
7-2 Relaying of trunk cables 7·1
7-3 Cable wiring procedure in control panel 7·2
7-4 Waterproof and insulation processing of connectors 7·4
7-5 Wiring of cables at outside control panels 7·5
7-6 Check after wiring 7·5
7-7 Wiring method for adding a communication station 7·6
7-8 Wiring to power supply module 7·8
Chapter 8 Remote I/O ............................................................................................................................. 8·1
8-1 Description of remote I/O 8·1
8-2 Data transfer required time and communication timing 8·3
8-3 Outline of switch and parameter setting procedure 8·8
8-4 Error and treatment 8·46
Chapter 9 Data Link ............................................................................................................................... 9·1
9-1 Description for data link function 9·1
9-2 Communication method 9·2
9-3 Data transfer required time and communication delay time 9·12
9-4 Expansion of network 9·15
9-5 Switch setting of master station or slave station 9·17
9-6 Setting contents of slave station parameters 9·22
9-7 Setting contents of master station parameters 9·33
9-8 Error and treatment 9·53
Chapter 10 Computer link ....................................................................................................................10·1
10-1 Description for computer link 10·1
10-2 Computer link function 10·2
10-3 Switch setting 10·3
10-4 Command 10·4