Sharp JW-20CM - Manual (Page 46)

8 · 8
8-3 Outline of switch and parameter setting procedure
In brackets: See page
Start
Power “OFF” master/slave station
Set switch of master module
Set switch of slave module
Set parameter of slave module
Set parameter of master module
End
[8·9]
[8·14]
[8·19]
[8·30]
· Make sure to turn “OFF” the power of the PC prior to setting the switch.
· Parameter must be started from the slave module first.
· Prior to setting the parameters of master module, set the operation mode of the JW-20CM
to “program mode.”
· Make sure to write the set parameters into the EEPROM on the JW-20CM after setting.
Remarks