Sharp JW-20CM - Manual (Page 143)

9 · 45
From the previous page
Set the number of sending bytes of the master station relay link [DCM (decimal), word]
• Set in parameter addresses 005000 to 005001
(8)
.
005000 (8)
005001
(8) Upper
Lower
• These top addresses should not overlap the register link area, or the flag area, or exceed the
setting range (0 to 256 bytes for each station, 256 bytes for all stations in total).
In case of setting 8 bytes: Using JW-13PG example for page 9·41
Display the contents of parameter addresses 005000 to
005001
(8)
Write 00008
(D)
after converting to decimal.
Screen display of JW-13PG
To the next page
04774 D 00000
04776 D 00000
I PARAM.
>05000 D 00008
to
Set the number of sending bytes of the slave station (01 to 77) relay link [DCM (decimal), word]
• Set the number of sending bytes in decimal on the parameter addresses 005002 to 005177
(8)
.
(set in each station, 2 bytes for each station).
These top addresses should not overlap the register link area, or the flag area, or exceed the
setting range (0 to 256 bytes for each station, 256 bytes for all stations in total).
Lower
Upper
005176 (8)
005177 (8)
Lower
Upper
005002 (8)
005003 (8)
to
(In case of setting 4 bytes for slave station 01, and set 8 bytes for slave station 02: Example of page
9·41)
Slave station 01
Write 00004
(D)
in parameter
addresses 005002 to 005003
(8)
.
Slave station 02
Write 00008
(D)
in parameter
addresses 005004 to 005005
(8)
.
Screen display of JW-13PG
Slave
station 01
(8)
Slave
station 77
(8)
05000 D 00008
05002 D 00004
I PARAM.
>05004 D 00008
Enter by decimal
Enter by decimal