Sharp JW-20CM - Manual (Page 192)

11 · 5
11-2 Remote function
(1) Remote programming and remote monitor
This paragraph describes the operation procedure of any other station's PC which is connected in the
satellite net. The following support tools are available:
Hand-held programmer .................. JW-13PG/12PG
Multipurpose programmer .............. JW-50PG
Ladder software ............................. JW-50SP
Note 1
• If the JW-20CM remotely programs or monitors the new JW30H model (JW-31CUH1/32CUH1/
33CUH1/33CUH2/33CUH3), they should be used in the combination below.
If the JW-20CM, to which a support tool is connected, has a 30H sticker, the JW-20CM will identify
the new JW30H model as conventional model (JW-31CUH/32CUH/33CUH).
If the JW-20CM, to which a support tool is connected, does not have a 30H 30Hn sticker, it must
be used with the following limitations.
Ex.:
· If the JW-13PG has a B sticker, it will identify the new JW30H model as JW20H (JW-22CU).
· If a support tool JW-50SP is used, it will identify the new JW30H model properly. However, it
cannot handle the secret function.
• If the JW-20CM remotely programs or monitors the conventional JW30H model (JW-31CUH/32CUH/
33CUH), they should be used in the combination below.
If the JW-20CM, to which a support tool is connected, does not have a 30H 30Hn sticker, it must
be used with the following limitations.
Ex.:
· If a support tool JW-13PG is used, it will identify the conventional JW30H model as JW20H (JW-
22CU).
· If a support tool JW-50SP is used, it will identify the conventional JW30H model properly. However,
it cannot handle the secret function.
JW30H
Conventional models
JW-22CM
(with 30Hn mark)
JW50H/70H/100H
JW-20CM
(with 30Hn
mark)
JW-13PG (with B mark)
JW-50SP
(Support tool)
JW30H
Conventional models
JW-22CM
(with 30H
30Hn mark) JW-20CM
(with 30H
30Hn mark)
JW50H/70H/100H
JW-13PG (with B mark)
JW-50SP
(Support tool)