Sharp JW-20CM - Manual (Page 175)

10 · 7
Read out current value of timer/counter/MD
Function Read out current value that specified timer/counter/MD
Command code 03
(H)
(MTC)
Writing mode assignment No
Operation condition of PC Unrelated
Assignable address
: When PC is except for JW50H/70H/100H
0000 to 0777
(8)
: When PC is JW50H/70H/100H
0000 to 0777
(8)
Set/reset timer/counter (1 points unit)
Function Set (timeup, countup) or reset (return to setting value) that specified
timer/counter
Command code 13
(H)
(SRT)
Specify writing mode 1 or 2
Operation condition of PC Unrelated
Assignable address
: When PC is except for JW50H/70H/100H
0000 to 0777
(8)
: When PC is JW50H/70H/100H
0000 to 0777
(8)
· "Writing mode assignment" is used to show whether writing to the PC memory has been enabled or
disabled.
0: Writing prohibited
1: Enable writing only to data memory
2: Enable writing all data.
No setting: Enable writing in any mode
Letters in brackets are
command name of BASIC
mode.
Letters in brackets are
command name of BASIC
mode.