Sharp JW-20CM - Manual (Page 142)

9 · 44
From the previous page
Set top address of register link area on slave station 01 to 77
(8)
(at standard function)/
number of offset bytes (at memory capacity save function)
Set in parameter addresses 004404 to 004777
(8)
. These top addresses should not overlap the
register link area, flag area, or any area used by other option module.
Slave
station
01
Lower
Upper
File number
·
In case of standard function, set top address by file address
(8)
.
In case of memory capacity save function, set number of offset
bytes.
004404
(8)
004405
(8)
004406 (8)
004407 (8) 00 (H) : The top address is the same address of the master station
regardless of the values set at of 004404 to 004405
(8)
.
80
(H)
: The top address is different from the address of the master
station (Offset is valid).
For the memory capacity save function, set in 80
(H)
. Slave
station
77 (8)
Lower
Upper
File number
·
004774 (8)
004775 (8)
004776
(8)
004777
(8) 00 (H)
80 (H)
• In case of setting 0 (the top address is 0440, the same as the address of the master station) in
parameter addresses 004404 to 004407
(8)
(slave station 01) and the offset byte number 8 and
“offset valid” on the parameter address 004410 to 004413
(8)
(slave station 02). (Example for 9·40)
Slave
station
01
Write 0 in parameter 004004 to 004007
(8)
(same as master
station).
Write 00008
(D)
(offset 8) in parameter addresses
004410 to 004411
(8)
.
Write 00
(H)
(file 0) in parameter address 004412
(8)
.
Write 80
(H)
(offset valid) in parameter address 004413
(8)
.
Slave
station
02
Screen display of JW-13PG
File address: OCT (octal), word
File number/flag: HEX (hexadecimal), byte
Set the "same" as or "different" from the
master station: HEX (hexadecimal) , bytes.
To the next page
04011 HEX 00
04012 HEX 00
I PARAM.
>04013 HEX 80