Sharp JW-20CM - Manual (Page 197)

11 · 10
Setting parameter
After finishing communication with the target station, set the parameters remotely.
Return to initial menu.
Turn the PC of the target station to program mode (stop PC operation).
Select “PARAM.” in the initial mode.
<>
Display contents of parameter address 003777
(8)
.
Write in 00
(H)
, stop operation of the JW-20CM.
<>
Display contents of parameter address 007777
(8)
.
Write in 00
(H)
, stop operation of the JW-20CM.
Input address Display contents of address to set the parameters.
Input setting value Setting parameter remotely.
Writing to the EEPROM, start operation
After setting the parameter remotely in step , write 81
(H)
at parameter address 003777
(8)
(when
at remote I/O function), or at 00777
(8)
(when at data link function), to start the "writing operation to
EEPROM."