SANRAD I3.1.1205 - Manual (Page 96)

6-4 SANRAD V-Switch CLI User Manual
You need to define two parameters to blink a storage device:
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-s STORAGE DEVICE ALAIS OF DEVICE
TO BLINK MANDATORY Stor_1
-t TIME LENGTH OF TIME TO
BLINK DEVICE OPTIONAL
1-3600 SEC
0= FOREVER
DEFAULT : 0
120
Example:
The storage device, Stor_1, is set to blink for two minutes (one hundred and
twenty seconds) to allow it to be identified.
storage blink activate –s Stor_1 –t 120
Use the CLI command storage blink abort to stop the blinking before the
end of the set time.
storage blink abort
You need to define one parameter to stop blinking a storage device:
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-s STORAGE DEVICE ALAIS OF DEVICE
TO BLINK MANDATORY Stor_1
Once a storage device has been identified, use the CLI command storage set
to change the device alias or include helpful information on the device.
storage set
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-s STORAGE ALIAS STORAGE ALIAS TO
MODIFY MANDATORY Stor_1
-na NEW ALIAS NEW ALIAS FOR
STORAGE OPTIONAL Disk2JBOD5
-info INFORMATION INFORMATION ON
STORAGE TO SET OPTIONAL save_for_snap
shots
Example: