SANRAD I3.1.1205 - Manual (Page 249)

Chapter 11: Command Line Interface 11-35
volume remove -all
This command removes a volume and all volumes composing it in the
hierarchy. The volume must be at the top of the hierarchy. The volume cannot
be exposed; the volume LU must be inactivated. Simple volumes will convert
back to their component disks or subdisks.
volume remove -all
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-vol VOLUME ALIAS ALIAS OF TOP -
LEVEL VOLUME TO
REMOVE
MANDATORY Stripe 1
volume replace
This command replaces a volume with another volume. Use this command
after a disk failure to replace a volume used in a storage hierarchy with a
volume on a functional disk.
If you are replacing a volume used as part of a mirrored volume, use the CLI
command volume mirror-synch to synchronize the replacement volume
with the other mirrored volume(s). See the working example: Appendix A
“
Error! Not a valid filename. ”.
volume replace
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-vol VOLUME VOLUME ON FAILED
DISK MANDATORY Simple4
-nvol NEW VOLUME REPLACEMENT
VOLUME MANDATORY Simple6