SANRAD I3.1.1205 - Manual (Page 33)

Chapter 2: Installing the V-Switch 2000 2-5
10210
1
2
1
2 5
4
3 3
Figure 2-5. V-Switch 2000 LEDs – FC
Surface Mounting
The V-Switch 2000 chassis is manufactured with four chassis feet. The V-Switch
2000 is ready to be mounted on any secure flat surface. If you plan to rack
mount the V-Switch 2000, continue with “Rack Mounting.”
Rack Mounting
The V-Switch 2000 chassis can be mounted on a 19-inch rack. The V-Switch
2000 can be mounted alone or two V-Switches can be joined and mounted
together in a single 1U space.
The V-Switch 2000 is shipped with an accessory packet of hardware. This
packet includes four non-identical L-brackets and twelve bracket screws for
rack mounting
You need the following tools to rack-mount the V-Switch 2000:
ƒ A Philips screwdriver suitable for L-bracket screws
ƒ Four rack-post screws (and clips if necessary) suitable for the
equipment rack
ƒ A screwdriver suitable for the rack-post screws
Remove the rubber feet from the bottom of the V-Switch before beginning the
rack mount to ensure a proper fit in the rack enclosure.