SANRAD I3.1.1205 - Manual (Page 206)

10-20 SANRAD V-Switch CLI User Manual
V-Switch 3000 Power Supply
The V-Switch 3000 is standard-issued with two hot-swappable AC power
supplies. If one of the power supplies fail, its red LED on the back panel turns
off. If both of the power supplies fail, the Power LED on the front panel turns
off.
STEP 1. D
ISCONNECT THE POWER CABLE
Disconnect the power cable from the power source. After the power cable
is disconnected from the power source, disconnect the power cable from
the V-Switch.
STEP 2. L
OOSEN THE POWER SUPPLY CONNECTING SCREW
Loosen the power supply connecting screw to release the power supply
from the V-Switch.
STEP 3. R
EMOVE THE POWER SUPPLY
Lift the power supply handle and pull to slide the power supply out
1024
3
connecting
screw
handle
Figure 10-3. Replacing a Power Supply
STEP 4. INSERT A FUNCTIONING COMPATIBLE POWER SUPPLY AND SECURE
Insert a functioning compatible power supply. Secure the power supply to
the V-Switch.
It is now safe to reconnect the power cable to the power supply and power
source.