Checking the ip configurations – SANRAD I3.1.1205 User Manual
Page 67
Chapter 4: V-Switch Configuration
4-15
S
WITCH
P
ARAMETER
D
EFINITION
S
TATUS
E
XAMPLE
-act
ACTIVITY
IF
IP
ADDRESS IS
ACTIVE TO EXPOSE
VOLUMES
.
U
SE
INACTIVE STATUS
TO ALLOW
FAILOVER
.
O
PTIONAL
D
EFAULT
:
1
(
ACTIVE
)
2
(
INACTIVE
)
1
For regular port activity, use the default active port setting. The inactive port
setting is used when configuring a V-Switch cluster. If you are configuring a V-
Switch cluster, each IP address must be configured on both V-Switches in the V-
Switch cluster. For more information on V-Switch clusters, see “
Introduction to
V-Switch Clusters
”.
Example:
The IP address 212.199.43.56 is assigned to the 1 Gb Ethernet port Eth1.
ip config set –ip 212.199.43.56 –if eth1 –act 1
1022
4
212.199.43.56
Figure 4-3. Ethernet Port 1 IP Address
Checking the IP Configurations
After setting the management and network port IP addresses, you can use the
CLI command ip config show to access the IP Configuration Table and
view all assigned port IP addresses.
ip config show
Table 4-3:
V-Switch IP Configuration Table
If Name
IP Address
Net Mask
Activity
mgmt
212.199.43.46
255.255.255.0
Active
eth1
212.199.43.56
255.255.255.0
Active
eth1
212.199.43.57
255.255.255.0
Inactive
eth2
212.199.75.66
255.255.255.0
Active
eth3
212.199.12.67
255.255.255.0
Inactive
eth3
212.199.12.70
255.255.255.0
Active