SANRAD I3.1.1205 - Manual (Page 77)

Chapter 4: V-Switch Configuration 4-25
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-if INTERFACE
ALIAS NETWORK PORT TO
OPEN
COMMUNICATION
THROUGH MANDATORY eth2
Example:
An IP routing path to Network D, IP 10.10.20.0, (IP mask 255.255.255.0) is
mapped from network port Eth2 through router gateway 30.30.20.20.
ip route add –dip 10.10.20.0 –dmask 255.255.255.0 –gw
30.30.20.20 –if eth2
Setting a Default Gateway
You can configure the default gateway for IP routes from two interfaces: 10/100
MBits Mgnt Interface or 1GBits ETH1 Interface. This gateway is used for any
IP address not specified in the V-Switch routing table. Use the CLI command
ip route default to
set the default gateway IP address for management
and Eth1. To change the default gateway, repeat the command with the new
default gateway IP address.
ip route default
You need two parameters to configure a default IP routing path.
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-gw GATEWAY IP ADDRESS OF
DEFAULT GATEWAY
MANDATORY 20.20.10.20
-if INTERFACE
ALIAS NETWORK PORT TO
OPEN
COMMUNICATION
THROUGH OPTIONAL
MGNT OR ETH 1
DEFAULT : ETH 1
eth1
ip route default –gw 20.20.10.20